DOI: 10.52150/2522-9117-2018-32-290-299
Poleshchuk Valentin Mikhailovich, PhD (Engin.), Executive Director, Association of scientific organizations of the mining and metallurgical complex of Ukraine, Academic square Starodubova, 1, Dnipro, Ukraine, 49107
Brovkin Vladimir Leonidovich, PhD (Engin.), docent, National Metallurgical Academy of Ukraine, Gagarina Avenue, 4, Dnipro, 49600
Scheme of stressed-deformed condition of continuous-casted slab in technological casting lines
Abstract. The aim of the work is to develop a model of the deformationstressed state of a continuous-cast billet, taking into account its behavior in the continuous casting machine line. A new physical model of the ingot crust bending process in the inter-roller gap has been proposed. The model is based on the regularities of the change in the deformed state of the surface of the crust under the action of ferrostatic pressure. It is established that the crust undergoes a cyclic alternating deformation in the process of oving it across the interroller gap. It is shown that the surface of the crust comes into contact with the surface of the roller before approaching the inter-roller gap. This causes the appearance of an anomalous area with a constant curvature of the crust at the final stage of its buckling. The second anomalous deformation zone of the ingot crust is the junction zone of the previous crust and the subsequent inter-roller gap, where the crust instantly changes its curvature. In combination with the flat scheme of the stress-strain state, a physical model is presented, which makes it possible to identify in each of the inter-roller gaps the zone of
maximum values of the tensile strain rate. Identifying the zone of maximum values of the tensile strain indicator and comparing it with the maximum allowable one allows determining and correcting the length of the inter-roller gaps of the continuous casting machine.
Key words: billet continuous casting machine, continuously cast billet, billet curvature, deformed state, physical model.
Reference
1. Bulanov L.V., Korzunin L.G., Parfenov Ye.P. Mashiny nepreryvnogo lit’ya zagotovok. – Kazan’: Marat, – 2003. – 319 s.
2. Poleshchuk V.M., Brovkin V.L. Deformirovannoye sostoyaniye nepreryvno¬litogo slitka s zhidkoy serdtsevinoy na krivolineynykh MNLZ. Fundamental’nyye i prikladnyye problemy chernoy metallurgii. Vypusk 30. – 2015. – S. 216-225.
3. Niskovskiy V.M., Karlinskiy S.Ye., Berenov A.D. Mashiny nepreryvnogo lit’ya slyabovykh zagotovok. – M.: Metallurgiya. – 1991. – 272 s.
4. Wunnenberg K., Dubendorf J. Strangausbauchung zwischen Stützrollen beim Stranggießen von Brammen. Stahl und Eisen. – 1978. – Vol. 98. – P. 254- 259.
5. Pal’mers A., Et’yen A., Min’on ZH. Raschet mekhanicheskikh i termicheskikh napryazheniy v nepreryvnolitoy zagotovke. Chernyye metally. –1979. – № 19. – S. 3-11.
