DOI: 10.52150/2522-9117-2022-36-507-521

Lapshin Evgeniy Semenovich, D. Sc. (Tech.), Leading Researcher, Institute of Geotechnical Mechanics named by N. Poljakov of National Academy of Sciences of Ukraine, Simferopolska Str., 2a, Dnipro, Ukraine, 49005. ORCID: 0000-0002-5443-5566. E-mail: les48@i.ua

Shevchenko Oleksandr Ivanovich, D. Sc. (Tech.), Senior Researcher, Institute of Geotechnical Mechanics named by N. Poljakov of National Academy of Sciences of Ukraine, Simferopolska Str., 2a, Dnipro, Ukraine, 49005. ORCID: 0000-0002-3759-7889. E-mail: alex-tpm@ukr.net

ANALYSIS OF TECHNICAL SOLUTIONS FOR DEHYDRATION AND CLASSIFICATION BY SIZE OF MINERAL RAW AT THIN AND ULTRAFINE VIBRATION SCREENING

Summary. The article is aimed at studying new technical solutions for dehydration and size classification in the case of fine and ultrafine vibratory screening of mineral raw materials. It is shown that the moisture content in many products is limited by GOST or temporary regulations. Water is the ballast in their transportation. An excessive amount of water contributes to the freezing of raw materials in winter conditions and causes great difficulties in unloading them from wagons. Traditional methods make it possible to effectively separate only materials with a particle size of more than 1 mm, and reduce the moisture content of the finished product to 18-22%, depending on the size, which does not meet the required standards. It is necessary to reduce moisture to 8-10% or less. In addition, the processing of various raw materials in most cases requires, simultaneously with dehydration, the separation of products of a wide range of sizes. To overcome the adhesion forces between wet particles, different excitations are used, one of which is a combined excitation that provides intensive movement of the liquid and particles relative to each other. Combined means excitation with various combinations of polyfrequency, impulse dynamic effects, and additional effects of various physical fields are also possible. The use of polyfrequency and impulse dynamic (“single impacts”) impacts on the MVG2.0 vibrating polyfrequency screen makes it possible to effectively separate the solid phase from the liquid when treating recycled water with a particle size of 20 microns. At the same time, the residual moisture in the oversize product is no more than 17%. The method of complex dehydration of wet mineral raw materials, combining three dehydration mechanisms (vibration, electrokinetic and vacuum), concentrated in one device, allows, at different initial moisture content of the raw material, to reduce the moisture content from 30 to 16%, from 20 to 14% and from 10 to 6%, t .e. reduce the humidity from 30 to 6% in several stages. These results were obtained for narrow size classes of 0.25÷0.63 mm. The use of modes with “double impacts” and disintegrating elements in the new vibro-impact screen made it possible to reduce the humidity from 30% to 8-10%. The separation efficiency of the +0–0.1 mm class was up to 65–70%. When using an activator, the moisture content of the material is reduced from 30% to 7-9%, and the separation efficiency of the +0-0.1 mm class is increased to 70-75%. Due to the use of a disintegrator over the activator, the moisture content of the oversize product was reduced to 6–8%, while the separation efficiency of the +0–0.1 mm class increased to 75–80%. Experimental method on the model of a vibro-impact screen for different fineness classes determined the conditions under which the maximum extraction of the class +0–0.1 mm and the decrease in humidity are determined. Currently, work is underway aimed at creating a vibro-impact screen, which will implement: expanding the range of impact on the processed material, increasing the life of the screen, the possibility of operational automatic control, increasing the stability of work and, at the same time, simplicity of design.

Key words: polyfrequency and impulse dynamic impact, complex dehydration, vibro-impact mode with “double impacts”, size separation, dehydration.

DOI: https://doi.org/10.52150/2522-9117-2022-36-507-521

For citation: Lapshin E.S., Shevchenko O.I. Analiz tekhnichnykh rishenʹ dlya znevodnennya ta klasyfikatsiyi za krupnistyu mineralʹnoyi syrovyny pry tonkomu i nadtonkomu vibratsiynomu hrokhochenni [Analysis of technical solutions for dehydration and classification by size of mineral raw at thin and ultrafine vibration screening]. Fundamental and applied problems of ferrous metallurgy. 2022. Collection 36. P. 507-521. [In Ukrainian]. https://doi.org/10.52150/2522-9117-2022-36-507-521

References

1. Beilin, M. I. (1969). Theoretical foundations of coal dehydration processes. [Teoreticheskiye osnovy protsessov obezvozhivaniya ugley]. Nedra
2. Meinel, A. (1999). Zu den Grundlagen der Klassierung sieschwieriger Materialien. Aufbereitungs-Technik, (7), 313–327
3. Lapshin, E. S., & Shevchenko, A. I. (2013). Ways to improve vibratory separation by size and dehydration of mineral raw materials. [Puti sovershenstvovaniya vibratsionnogo razdeleniya po krupnosti i obezvozhivaniya mineral’nogo syr’ya]. Naukovyy visnyk Natsionalʹnoho hirnychoho universytetu, (3), 45–51
4. Dehydration on multifrequency vibration machines. http://www.vtcenter.ru/articles/coal_atic.htm
5. Questions and answers. http://www.kroosh.ru/%20?Voprosy_i_otvety%26nbsp
6. Lapshin, E. S., & Shevchenko, A. I. (2012). Analysis of the state of development of vibratory screening during dehydration of mineral raw materials. [Analiz sostoyaniya razvitiya vibratsionnogo grokhocheniya pri obezvozhivanii mineral’nogo syr’ya]. Geo-Technical Mechanics, 101, 84–104
7. Patent 45544, (2009). Drive polyfrequency screen [Privod polichastotnogo grokhota].Bull. 21
8. Bulat, A. F., Shevchenko, G. A., Shevchenko, V. G., & Shlyakhova, M. A. (2014). Vibrating polyfrequency screens in technologies for processing fine fractions of mineral raw materials [Vibratsionnyye polichastotnyye grokhoty v tekhnologiyakh pererabotki tonkikh fraktsiy mineral’nogo syr’ya]. Nauchno-tekhnicheskoye obespecheniye gornogo proizvodstva, 86, 112-118
9. Bulat, A. F., & Shevchenko, G. A. (2010). Influence of polyfrequency vibrations of screening surfaces of vibrating screens on the separation of bulk materials [Vliyaniye polichastotnykh kolebaniy proseivayushchikh poverkhnostey vibratsionnykh grokhotov na razdeleniye sypuchikh materialov]. Naukovyy visnyk Natsionalʹnoho hirnychoho universytetu, (4), 92-97
10. Shevchenko, G., Shevchenko, V., & Bobylev, A. (2013). Vibrating screens with polyfrequency vibrations of screening surfaces for fine separation. [Vibratsionnyye grokhoty s polichastotnymi kolebaniyami proseivayushchikh poverkhnostey dlya tonkogo razdeleniya]. Coal of Ukraine, 2, 23-27
11. Shevchenko, G. A., & Shevchenko, V. G. (2012). On the feasibility of using a vibrating multi-frequency screen for cleaning circulating water when washing ore rof [O tselesoobraznosti ispol’zovaniya vibratsionnogo polichastotnogo grokhota dlya ochistki oborotnoy vody pri promyvke rudy rof]. Geo-Technical Mechanics, 104, 120-125
12. Patent 89501, Ukraine. (2014). Device for dewatering loose materials [Prystriy dlya znevodnennya sypkykh materialiv].Bull. 8
13. Naduty, P., Sukharev, V. V., & Kostyria, S. V. (2014). The results of complex dehydration of the rock mass on a vibration device [Rezul’taty kompleksnogo obezvozhivaniya gornoy massy na vibratsionnom ustroystve]. Vibratsiyi v tekhnitsi ta tekhnolohiyakh, (1), 88-93
14. Patent 65469, Ukraine. (2011). The method of screening and dehydration of mineral raw materials, which is difficult to classify [Sposib hrokhochennya ta znevodnyuvannya mineralʹnoyi syrovyny, shcho vazhko klasyfikuyetʹsya]. Bull. 23
15. Patent 67194, Ukraine. (2012). The method of screening and dehydration of materials that are difficult to classify [Sposib hrokhochennya ta znevodnyuvannya materialiv, shcho vazhko klasyfikuyutʹsya]. Bull. 3
16. Patent 77362, Ukraine. (2013). A method of size separation and dewatering of bulk material that is difficult to classify [Sposib rozdilennya za krupnistyu ta znevodnyuvannya sypuchoho materialu, yakyy vazhko klasyfikuyetʹsya]. 3
17. Lapshin, E. S., & Shevchenko, A. I. (2011). Ways of intensification of dehydration of mineral raw materials on vibrating screens [Puti intensifikatsii obezvozhivaniya mineral’nogo syr’ya na vibratsionnykh grokhotakh]. Zbahachennya korysnykh kopalyn, 47, 144-151
18. Shevchenko, A. I. (2013). Intensification of separation by size and dehydration of mineral raw materials with a new method of vibro-impact screening [Intensifikatsiya razdeleniya po krupnosti i obezvozhivaniya mineral’nogo syr’ya pri novom sposobe vibroudarnogo grokhocheniya]. Zbahachennya korysnykh kopalyn, 54, 157-166
19. Naduty, V. P., Lapshin, E. S., & Shevchenko, A. I. (2011). Mathematical modeling of a screen with shock excitation of the screening surface. [Matematicheskoye modelirovaniye grokhota s udarnym vozbuzhdeniyem proseivayushchey poverkhnosti]: Automation of manufacturing processes in machine-building and accessories. Lviv Polytechnic, 45, 320-324
20. Shevchenko, O. I. (2021). Development of the scientific foundations of the process of vibro-impact dehydration of man-made raw materials of varying granulometric composition [Rozvytok naukovykh osnov protsesu vibroudarnoho znevodnennya tekhnohennoyi syrovyny hranulometrychnoho skladu, yakyy zminyuyetʹsya]. Autoref. thesis … Dr. technical Sciences: 05.15.09. Dnipro